Parts & Assembly; Motor Housing - Nostalgia Electrics Coca-Cola Serie Instrucciones Y Recetas

PARTS & ASSEMBLY
Your FROZEN BEVERAGE STATION requires very little assembly:
• The FROZEN BEVERAGE STATION has a sharp stainless steel blade that can cut and
cause injury. Use EXTREME CAUTION when handling the appliance. Keep fingers
clear from blade and avoid contact at all times when using and cleaning.
• Before first use, thoroughly wash the Ice Shaving Chamber, Lid, Pitcher
and Mixing Paddle in warm, soapy water with a non-abrasive sponge or
cloth. Dry thoroughly. DO NOT put Motor Housing or Base in water.
• Wipe clean the exterior Motor Housing, Base and inside of the unit with a non-
abrasive moist sponge or a damp cloth followed by a non-abrasive dry towel.
• After cleaning the inside, put the Ice Shaving Chamber into the Motor Housing so it is
seated on the shaft. Twist the shaft in the direction of the arrow to lock into position.
• Insert the Mixing Paddle into the slot in the center of the Pitcher.
Now you are ready to enjoy cool, refreshing frozen beverages
from your FROZEN BEVERAGE STATION!

Motor Housing

Ice Shaving
Chamber
Lid
5
Base
Mixing Paddle
Selector Knob
BPA Free
Pitcher