Cleaning The Soft Roller; Checking The Nozzle For Blockages - Shark APEX DuoClean AX910 Serie Instrucciones

CLEANING THE SOFT ROLLER

1
Push up both sliders on floor nozzle at the
same time to pop up the brushroll garage
lid.
2 To remove Soft Roller from nozzle, lift it out
by the pull tab on the right side.
3 You can also tap loose debris off the Soft
Roller, or wipe it clean with a dry towel. If
you see any hair buildup or fibers caught in
the teeth behind the Soft Roller, wipe clean
with a dry towel.
4 Wash the Soft Roller as needed. Use only
water, and let air-dry completely for at least
24 hours.
5 Reinsert Soft Roller until it is secured, then
place the garage door lid onto the nozzle and
press down until it securely clicks in place on
both sides.

CHECKING THE NOZZLE FOR BLOCKAGES

1
Tilt neck of nozzle back to straighten the
airway, then remove any blockages from
nozzle.
s h a r kc l e a n . c o m
20