Cleaning Modes; Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Dust Cup - Shark Ninja WV361EU Serie Manual De Instrucciones

CLEANING MODES

UPRIGHT WITH WAND
To clean floors, place foot on floor nozzle and tilt
handheld vacuum back.
NOTE: To remove accessories from the handvac, press
the two release tabs on the side of the unit.
ABOVE-FLOOR WITH ACCESSORY
Attach desired accessory to handheld vacuum.
Press buttons on both sides of the handle to
remove accessory.
NOTE: All accessories are compatible with both the wand and the handheld vacuum.
42
s h a r kc l e a n . e u
ABOVE-FLOOR HANDHELD
To detach the handheld vacuum from the wand,
press the buttons on both sides of the handle, and
lift the handheld vacuum off the wand.
To reattach the handheld vacuum to the wand,
align the nozzle over the top of the wand and slide
it on until it clicks into place.
ABOVE-FLOOR WITH WAND
For more reach to clean above-floor areas, detach
the floor nozzle from the wand. Step on the floor
nozzle, and press the nozzle release button at the
bottom of the wand. Lift the wand to remove it.
To reattach the wand, align it over the nozzle neck,
then slide it on until it clicks into place.

MAINTAINING YOUR VACUUM

EMPTYING THE DUST CUP

1. With the power off, slide the release button
forward, and the dust cup will swing open. Tap
the filter screen lightly to knock off dust and
debris.
CLEANING THE DUST CUP AND FILTER
1. With the dust cup open and the power off, press the
filter release latch on the bottom of the handle and
pull out the filter housing.
NOTE: Do not wash any parts or accessories in a dishwasher.
1
2. Wipe dust screen lightly with cloth to remove
dust and dirt.
1
2. Press the tabs on both sides of the filter housing
and pull out the filter. To clean the dust cup and
filter, rinse them with lukewarm water only. Allow
all parts to air-dry completely. To reinstall the filter,
slide it back into the housing and press into place.
s h a r kc l e a n . e u
2
2
43