Installing The Jogger On Your Carrier; Attaching The Wrist Tether - Burley JOGGER CKIT Instrucciones Del Propietario Y Manual De Seguridad

Installing the Jogger on your Carrier

Only Install the Jogger when the trailer is unoccupied. Engage the parking brake on your trailer and
detach the trailer tow bar. (See your trailer manual for instructions for removing the tow bar.)
1. Observe [Figure 1] to see completed installation. Note the inward curve of the bars, and the
downward facing towbar mounts. You will install the arms first one at a time, and then insert the
wheel.
2. To install the arms you must first open the wheelguards. Squeeze buttons (2a) on top and bottom of
wheelguard to open (Figure 2).
3. Slide the arms into the receiver until holes (3a) and (3b) are aligned [Figure 3].
4. Insert the safety pin from the top through the aligned holes [Figure 4] and lock the pin closed. Then
close the wheelguard until it clicks.
5. The arm is now secured by both the safety pin and wheelguard. Make sure the pin is locked closed
as shown [Figure 5].
6. Insert the quick release lever skewer through the hub of the wheel, making sure there is a spring
on either side of the hub. Screw the nut on loosely [Figure 6].
7. Place the wheel in the wheel dropouts [Figure 7].
8. With the QR handle perpendicular to the wheel, tighten the nut so that you feel resistance halfway
through closing the lever. Do not tighten the quick release lever by spinning the lever.
9. Close the quick release lever. The lever should point to the rear of the Jogger.
10. Make sure your handlebar is at the right height for jogging. If necessary, adjust the handlebar to a
better height.
11. Make your final adjustments. Check that the wheel is aligned upright at 90° [Figure 8]. If it is not,
loosen the bolts on the sides of the wheel dropouts, align the wheel and then tighten the bolts. If
you have any questions about these adjustments, please contact your Authorized Burley Dealer.

Attaching the Wrist Tether

Around the handlebar center, slide the tether strap end through the loop on the other end of the strap
and tighten securely.
Maintenance
Make sure all of the nuts and bolts are secure. If you have any questions about the operation and
maintenance of your Jogger, please contact your Authorized Burley Dealer.
Figure 7
Figure 8
JOGGER KIT
90°
8