Opening Your Trailer; Installing The Wheel Guards; Attaching The Wheels - Burley TAIL WAGON Manual De Instrucciones Y De Seguridad

Opening Your Trailer

1. Raise front frame tube and rear frame tube from
inside the trailer until they sit together on the
plastic saddles (Figure 1).
2. Lock bars together by pushing down on latches
(Figure 2).
Closing Your Trailer
1. Remove all contents from the trailer.
2. Release frame latches and push rear frame under
front frame.
WARNING
Check that the frame locks are properly engaged before using the trailer. Failure to do
so can result in serious injury.
Care must be taken when folding and unfolding to prevent finger entrapment.
Installing Wheel Guards
1. Insert wheel guard bolts through frame tube.
Match holes in wheel guards to bolts. Tighten securely
with hex key (Figure 3).
2. Repeat for wheel guard on other side of trailer.

Attaching the Wheels

1. Push in the rubber button on the outside of the
wheel hub (Figure 4).
2. Insert wheel axle into axle receiver, and then release
the button (Figure 5). Pull firmly on wheel to confirm
the axle is fully engaged.
OWNER'S INSTRUCTION & SAFETY MANUAL
Front
Figure 1
Figure 3
Rear
Figure 2
Figure 4
BURLEY.COM
Figure 5
ENG 5