Installing The Wheel Guards; Installing The Tow Bar; Removing The Tow Bar - Burley BARK RANGER Manual De Instrucciones Y Seguridad

Installing the Wheel Guards

1. Position the wheel guard as shown (Figure 14).
2. Slide the wheel guard into the tow bar receiver until it snaps
into place (Figure 15). Lightly bend front tabs inward when
inserting.
3. Repeat on other side.

Installing the Tow Bar

1. Depress detent and slide the tow bar receivers until
hole A is aligned with hole B (Figure 16).
2. Insert the retaining pin from the top through the
aligned holes (Figure 17).
3. Make sure the retaining pin has locked properly as
shown (Figure 18).

Removing the Tow Bar

1. Remove the retaining pin.
2. Press the tab on the wheel guard to depress
the detent, and remove the tow bar.
ENG
8
Figure 14
Figure 16
Figure 18
®
Figure 15
A B
Figure 17
PET TRAILERS