Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
•
Seat the person so that their head is approximately at your eye level.
•
Before cutting, always comb the hair so it is tangle free and dry.
TO ATTACH A COMB
•
Hold the comb with its teeth upward.
•
Slide it onto and along the clipper blade until the front of the comb firmly sits against
the clipper and click into position.
TO REMOVE THE COMB
•
Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
•
Each comb attachment is marked accordingly on its outside middle surface.
•
Please note a 0.5mm cutting length can be achieved from holding the clipper, with no
comb attachment, perpendicular to the skin. A 1.0mm cutting length is achieved from
holding the clipper, with no comb attachment, with the top of the blade surface in
contact with the skin.
•
This is with the taper setting set at the closest gap between the blades.
INSTRUCTIONS FOR CUTTING HAIR
•
For even cutting, allow the comb attachment/blade to cut its way through the hair. Do
not force it through quickly. If you are cutting for the first time, start with the maximum
comb attachment.
STEP 1 – Nape of the neck
•
Attach the 3mm or 6mm fixed comb
•
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
•
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – Back of the head
•
With the 12mm or 16mm guide comb attached, cut the hair at the back of the head.
4
Guide Combs
1 (# 0)
2 (# 1)
3 (# 2)
4 (# 3)
5 (# 4)
6 (# 5)
7
8
9
Cutting Length (mm)
1.5
3
6
9
12
16
18
22
25
Publicidad
Tabla de contenido
