After Each Use; Every Six Months - Remington ColourCut HC5038 Manual Del Usuario

STEP 3 – Side of the head
• With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
9mm guide comb and continue to cut the top of the head.
STEP 4 – Top of the head
• Use the longer length fixed combs of 22mm or 25mm to cut hair on top of the head
against the direction in which the hair normally grows.
• Always work from the back of the head.
STEP 5 – The finishing touches
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin
and then work downwards.
SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
• Starting with the longest fixed comb (25mm), cut from the back of the neck to the
crown. Hold the guide comb flat against the head and slowly move the clipper through
the hair.
• Use the same procedure from the lower side to the upper side of the head. Then cut the
hair against the direction in which it grows and level with the sides.
• To give a "flat top" look, the hair on top of the head must be cut over the top of a flat comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
CARE FOR YOUR HAIRCLIPPER

AFTER EACH USE

• To ensure long lasting performance of your clipper, clean the blades and unit regularly.
• Ensure the appliance is switched off and unplugged from the mains before cleaning.
• Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
• We recommend oiling the blades after cleaning with a little sewing machine oil.
• Note: Ensure the clipper is turned off when cleaning.

EVERY SIX MONTHS

• At regular intervals the blade set should be removed and cleaned.
• The blade set can be removed and reinstalled by using a screwdriver.
• Brush out hair and do not use water or cleaners on the blade set or internal body
housing.
CAUTION:
• Do not use liquid cleaners on the blades or harsh or corrosive chemicals on the blade
casing. Always use a soft brush to remove the accumulated hairs.
• Always store this appliance and cord in a moisture-free area.
• Do not wrap the supply cord around the appliance.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5