SATA 05801 Manual Del Uso página 19

Operation
1) Enabling/disabling (see Figure B)
- Press and hold switch (1) to start the machine, and release it to stop the machine.
- The switch has a function of braking. After the switch is released, the collet stops rotating immediately.
- The magnitude of force applied on the switch can change the speed. The change range is from 0 to the maximum speed. With small
force, low speed, slow and steady drilling, it is easy to control the electric drill.
- Do not allow the machine to stop operating because of the excessive load.
Warning
Do not operate at low speed for a long time; otherwise, the internal of the machine will generate overheating reaction.
2) Switch locking (see Figure B)
- The switch has the function of locking protection, which is conducive to avoiding incorrect start-up of the electric hand drill when it is not
in use. Adjust the steering deflector rod (2) to the center position in order to lock the machine.
3) Change of the rotation direction (see Figure B)
- Forward rotation: Push the side marked with "
and screwing in screws. Reverse rotation: Push the side marked with "
which can be used for loosening or screwing out screws.
Warning
Do not change direction until the machine is completely stationary.
4) Adjustable speed (see Figure C)
- Move the transmission lever forward to shift to "1": high torque/low speed. It is used for drilling a thicker bit thicker bit or screwing in screws.
- Move the transmission lever backward to shift to "2": low torque/high speed. It is used for drilling a thicker bit finer bit.
- When the mechanical transmission lever cannot be moved due to the impact of gears, gently press the switch to rotate the motor and then shift.
Warning
Do not change the speed until the machine is completely stationary.
5) Installation or removal of bit (see Figure D)
- Note: When installing or removing the drill, check whether the electric drill has been turned off and the battery pack has been taken out.
- -Hold the machine with one hand, hold the collet collar with the other hand, turn it anticlockwise to open the collet, install the bit into the collet,
push it to the end as far as possible, and then turn the collar clockwise to tighten the collet. When removing the bit, hold the collar and rotate it
anticlockwise.
05801/05802
" on the steering deflector rod to the end (move to the left side), which can be used for drilling
中文
EN
" on the steering deflector rod to the end (move to the right side),
DE RU KO PT JA ES
19