Technical Data - V2 LOKI Manual De Instrucciones

Transmisor 434,15 mhz para toldos y persianas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PRODUCT DESCRIPTION AND
DESTINATION OF USE
This radio transmitter is intended exclusively for the remote
control of radio receivers (or control units) of V2 automations for
outdoor blinds, sun screens or roller shutters.
Any other use other than that described is to be considered
improper and prohibited! Improper use can cause danger or
damage to property or persons.
The transmitter has three control keys:
UP:
activates the UP operation
STOP:
stops the automatism
DOWN: activates the DOWN operation
The LOKI1 model has 3 control keys associated with a single
transmission code.
The LOKI2 model has 6 keys divided into two groups of
three, as shown in fig. 1. Each group is associated with its
own transmission code, with the result that two independent
transmitters are available in the same shell.
The LOKI4 model has 4 single selection keys (1, 2, 3, 4), a global
selection key ALL and three control keys (UP, STOP, DOWN). Each
selection key has its own transmission code, and therefore, it is
like having 4 independent transmitters in the same shell.
Using the ALL key, all 4 channels are selected.
To command an automation, first press the selection button for
the automation and then send the commands with the command
buttons.
The selected automation remains in memory until another
selection key is pressed to choose another automation.
The transmitter is equipped with a wall support (fig. 3).
To fix the support use the supplied adhesive (if the surface is
smooth and compact), or use the supplied screw and plug (fig. 3).

TECHNICAL DATA

Power supply: 1 x Lithium 3V (CR2032 230mAh)
Frequency: 434,15MHz
Range in open field: 300m
Max.absorption: < 25 mA
UE DECLARATION OF CONFORMITY
V2 SPA dichiara che i prodotti:
LOKI
comply with the following directives:
2014/53/EU
ROHS2 2011/65/CE
The full declaration of conformity is available on the website
www.v2home.com in the section:
Products / Transmitters and Receivers / LOKI
REPLACING BATTERY
Replace the battery when the radio range power decrease or
the led light intensity becomes too feeble. Open the door of
the battery compartment and replace the battery respecting the
polarity shown by picture 2.
WARNING: Batteries contain pollutant elements, must be
disposed of in accordance with environmental regulations (V2
advise to use a specific disposal system).Transmitter contains
pollutant elements too; follow the same procedure to dispose.
Should the batteries lose electrolytic substances, please replace
them immediately avoiding with care any contact with such
substances.
ACTIVATION OF THE SUN SENSOR ON
A CONTROL UNIT
Press and hold down the STOP+UP keys until the motor confirms
the operation by moving in both directions.
DEACTIVATION OF THE SUN SENSOR
ON A CONTROL UNIT
Press and hold down the STOP+DOWN keys until the motor
confirms the operation by moving in both directions.
- 7 -

Publicidad

Tabla de contenido
loading

Tabla de contenido