Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK TRANSMITTER DATA STORAGE
m
CAUTION: The data storage of the first transmitter
determines the direction of motion of the motor.
m
CAUTION: If the awning has a casing carry out the
data storage of the first remote control by following the
procedure "TRANSMITTER DATA STORAGE"
To store your remote controls on a virgin control unit which
drives a shutter or an awning (WITHOUT casing) proceed as
follows:
1.
Supply power only to the control unit to be programmed
2.
Activate the programming by following one of these
procedures
LOKI1:
•
Press and hold down the UP+DOWN keys until the motor
starts to move in one direction
LOKI2:
•
Press the UP+DOWN keys of one of the two channels until
the motor starts to move in one direction
LOKI4:
•
Press and release the key of the channel to be programmed,
the LED will light up
•
Press the UP+DOWN keys until the motor starts to move in
one direction
3.
Release the keys: the motor stops
4.
Press the UP or DOWN keys according to the direction in
which the roll-up shutter was moving before it stopped:
- if the roll-up shutter was being raised press the UP key;
direction obtained: the UP key raises the roll-up shutter, the
DOWN key lowers the roll-up shutter
- if the roll-up shutter was being lowered press the DOWN
key; direction obtained: the DOWN key lowers the roll-up
shutter, the UP key raises the roll-up shutter.
5.
Programming is complete
To add additional remote controls, proceed as follows:
6.
Press and hold down the UP+DOWN keys of a remote control
which has already been programmed until the motor starts to
move in one direction
7.
Release the keys: the motor stops
8.
Press the UP or DOWN key of the new remote control
ADVANCED PROGRAMMING
To perform ADVANCED programming it is necessary to activate
the programming by following one of the following procedures:
ACTIVATION OF PROGRAMMING
LOKI1:
•
Press the STOP + UP + DOWN keys
•
When the LED lights up, release all the keys
•
Programming is activated for 30 seconds
LOKI2:
•
Press the STOP + UP + DOWN keys of the channel to be
programmed
•
When the LED lights up, release all the keys
•
Programming is activated for 30 seconds
LOKI4:
•
Press and release the key relative to the channel to be
programmed, the LED will light up
•
Press the STOP + UP + DOWN keys, the LED goes off
•
When the LED lights up, release all the keys
•
Programming is activated for 30 seconds
Note: this procedure will be the same for the programming
of all functions and will not be repeated in the following
paragraphs
NOTE: to activate the programming only 1 channel must be
selected.
Below is the list of programmable functions and the number of
corresponding flashes during the programming phase
NUMBER OF
FUNCTION
FLASHES
1
Transmitter memorization and sunshade shutter
mode selection
2
Transmitter memorization and roll-up shutter
mode selection
3
Deletion of all memorized transmitters
4
Upper position of the end-of-stroke
5
Lower position of the end-of-stroke
6
Intermediate position
7
Wind sensor intervention threshold
8
Sun sensor intervention threshold
9
Temperature level
- 8 -
Publicidad
Tabla de contenido
