Maruyama BC2259 Manual Del Propietário página 4

LOOP HANDLE (BC2259)
1. Place the rubber sleeve around the shaft.
2. Place the loop handle and the bracket over the rubber sleeve.
3. Install the four screws and nuts. Tighten the screws evenly.
STOP SWITCH WIRING
Plug the stop switch wires into the matching connectors from the engine.
Note that wire polarity is not important.
THROTTLE CABLE WIRING
The cable lug must be inserted into and through the cable adjuster sleeve
held by the bracket on top of the carburetor. Make sure the end of the cable
housing is seated positively in the sleeve. The cable lug fits into the slotted
fitting as shown.
A HOLE IS PROVIDED FOR THE LUG AT ONE END OF THE SLOT.
Operate the throttle trigger a few times to make sure that it works correctly.
Adjust the cable adjuster sleeve so the stop on the carburetor throttle cam
just contacts the throttle stop when the throttle trigger is depressed. When
the throttle cable is adjusted correctly, tighten the lock nut.
[BCF429H, BCF509H]
Clamp the throttle cable assembly with two bands as shown.
[BC429H]
Clamp the throttle cable assembly as shown.
[BCF429H, BCF509H]
Caution! : This swivel stopper is exclusively for fixing the handle in trans-
port. Do not engage the swivel stopper while operating the brushcutter.
In transport and storage:
Loosen the wing nut, place the stopper on A position of the bracket.
Tighten the wing nut, confirm the handle is fixed by the swivel stopper.
In operation:
Before start operation of the brushcutter, disengage the swivel stopper.
Loosen the wing nut, place the stopper at B position. Tighten the wing nut
to fix there, confirm the handle becomes free to turn around.
Screws (4)
— US-3 —
Loop Handle
Shaft
Rubber sleeve
Nuts (4)
Bracket
Matching
Connectors
Stop Switch Wires
Cable Adjuster Sleeve
Lock nut
Throttle Cable
Cable Lug
Carburetor
Bracket
Recessed Hole
Slotted fitting
Throttle cable
assembly
Band (2)
【 BCF429H, BCF509H 】
【 BC429H 】
Bracket
"A" Position
Swivel
Stopper
"B" Position
Wing Nut
[BCF429H, BCF509H]