Installing Debris Shield; Cutting Blade - Maruyama BC2259 Manual Del Propietário

INSTALLING DEBRIS SHIELD

DEBRIS SHIELD
Attach the debris shield to the gearcase with the two M6 x 30 screws as
shown on Fig. 1.
SHIELD EXTENSION
(Install the string cutoff blade and shield extension to the debris shield.)
1. Insert the square nut into shield extension as shown on Fig. 2.
2. Attach the String Cutoff Blade to shield extension using M5 x 20 Screw,
locking with square nut (on Fig.2) as shown on Fig. 3 .
3. Enter the guide in the slot of debris shield on Fig. 4. Make sure place
the three hooks into the position on the shield as shown on Fig.5.

CUTTING BLADE

A variety of metal cutting blades are available
to satisfy different cutting conditions. It is
especially important to use only the correct
blade(s) approved for each model brushcut-
ter. Also, it is especially important to install the
blade for LEFT- HAND rotation (as viewed
from the operator's position), and to correctly
position all blade holding parts (see sketch).
Debris Shield
Shield extension Hook
Stabilizer
Washer
Cutting Blade
Holding Tool
(3.5mm Pin)
Boss
Adapter
Gear case
【 BC2259, BC2259H, BC329H 】
— US-4 —
M6 x 30 Screw (2)
Gearcase
Debris Shield
Shield extension
Square nut
String Cut off Blade
M5 x 20 Screw
Guide
Hook
Fig.4 Fig.5
Stabilizer
Washer
Cutting Blade
Boss
Adapter
Gearcase
Holding Tool
( φ 6mm Pin)
【 BC429H, BCF429H, BCF509H 】
Fig.1
Fig.2
Fig.3