Registering A Handset - Konftel DECT base station Guia De Inicio Rapido

DESCRIPTION AND CONNECTION
Konftel DECT base station is GAP/CAT-iq-compatible for analogue
connection to the telephone network.
Key and LED
Connection
Connect the base station to a telephone jack and the mains using
the power adapter as illustrated.
Wall suspension
The base station can be mounted on the wall. Use the screws
provided as illustrated. Make sure it is securely mounted.
Screw
92mm
Holes for wall suspension
Power supply Line connection
2m

REGISTERING A HANDSET

(CONFERENCE PHONE)
A DECT-handset or a DECT conference
phone has to be registered with a DECT
base station before it can be used.
Please refer to your handset/conference
phone user guide if you are unsure.
 If you have purchased a Konftel 300Wx
with base station, the conference phone
is already registered.
Set the Konftel DECT base station
in registration mode
To be able to register a handset, the base
station has to be put into registration mode.

Hold down the key/LED on the base
station for at least 3 seconds.
The LED flashes rapidly.
The base station is now in registration mode.
Once registration has been completed, the
LED will stop flashing. If the base station
does not identify a DECT phone within 10
minutes, the registration mode will switch off
automatically.
PIN-code
During the registration, you must enter the
base station security code (PIN code) into
the handset.
PIN-code 0000
PARK-code Not used