Operation - Hilti SIW 18T-A Manual De Instrucciones

7 Operation

7.1 Changing sockets
NOTE
To ensure that the socket is held securely, the tool is equipped with a ½"
square drive with ball-notch retention or a ¾" square drive with locking pin.
7.1.1 Changing the socket (½" square drive with ball-notch reten-
tion)
NOTE
Bring the notch in the socket into alignment with the ball on the square drive
before fitting it to the power tool. The socket will not be held securely and
could fall off inadvertently if this point is not observed.
7.1.1.1 Fitting the nut driver
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Align the hole in the side of the nut driver with the retention ball on the
square drive.
3. Push the nut driver onto the chuck until it engages.
7.1.1.2 Removing the socket
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the socket away from the square drive spindle.
7.1.2 Changing the socket (¾" square drive with locking pin)
7.1.2.1 Fitting the socket
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Remove the O-ring from the groove in the socket.
3. Pull out the locking pin.
4. Place the socket on the square drive spindle of the tool.
Printed: 27.08.2013 | Doc-Nr: PUB / 5136086 / 000 / 01
3
4
5
en
15