Activation Of Card Reader - Fermax 2260 Manual De Instalación

Activation of card reader

To activate the reader the MASTER card must be programmed. This is the
card that will serve, later, to access to the preogramming functions. The other
KIT functions will be operative even though the card reader is not activated.
The system will take as MASTER card the first one shown to it after the power
has been switched on.
+ -
1. Mark one of the cards as
MASTER. This card may not
be used as a personal card.
It is very important not to lose the MASTER card, as it will be necessary to
activate or deactivate the personal cards.
If the MASTER card is lost or needs to be replaced, the following steps must
be taken (we recommend you entrust this task to specialised personnel).
1. Disconnect power supply.
2. Push door open button from the inside (if installed) or make a momentary
short circuit between terminals "B" and "-" of the reader controller. Reconnect
power supply.
3. The reader will go into "MASTER card change mode". All the reader's
indicators will start to blink for 5 seconds. The card shown to the reader
during this time will be taken as the new MASTER card.
The card shown must not be already activated as a personal card.
If the card shown is the one ALREADY used as MASTER, the reader will
remain inoperative, with the green indicator blinking constantly until power
is switched off. When power is reconnected, the reader will be deactivated,
that is, waiting to activate a new MASTER card.
NOTE:
The reader returns to normal mode, from any other programming setting, if no
card has been shown within a 30 second period.
+ -
2. Show the card to the
reader.
+ -
+ -
Beep!
3. The reader is now activated and
+ -
ready for operation after
activation of the necessary
personal cards.
+ -
Pag 13