Activation Of Personal Cards; Deactivation Of Personal Cards - Fermax 2260 Manual De Instalación

Activation of personal cards

A total of up to 400 cards may be activated, following these steps:
Beep!
-
+
1. Show the MASTER
card. The indicators
will display "activate
card mode."
A "beep" indicates that the card has been correctly activated. If not, indicates
that card had been activated previously, or that the card is faulty.
Annotate the number ef each card for future references.
If you try to activate more than 400 cards, the system will indicate "overload"
( "+" indicator blinking for 5 seconds).

Deactivation of personal cards

To deactivate cards in the system they must be physically available. The
procedure is as follows:
Beep!
Beep!
-
+
1. Show the MASTER
card (twice). T h e
indicators will display
"deactivate card
mode."
To deactivate cards without having them available see note on page 16.
Pag 14
Beep!
-
- +
+
2. Show the cards to be activated
one at a time.
Beep!
-
- +
+
2. Show the cards to be deactivated one
at a time.
One "beep" indacates that the card has
been deactivated, If not it means that
the card was not activated.
Beep!
-
-
+
+
Beep!
-
-
+
+
Beep!
Beep!
Beep!
Beep!
+ -
-
+
3. Show the MASTER card
at the end, until the
indicators display "nor-
mal mode."
Beep!
Beep!
Beep!
+ -
-
+
3. Again show the MAS-
TER card at the end, until
indicators display "nor-
mal mode."
+ -
+ -