Publicidad
Step 7
Step
NOTE: You may need to use the SHORT SCREWDRIVER
å
to tighten some of the HIDDEN CAMS in this step.
Insert fi ve METAL PINS (1R) into the LEFT END (B).
å
Fasten the LEFT END (B) to the BOTTOM (G), SHELF (H),
å
and FRONT PANEL (L). Tighten fi ve HIDDEN CAMS.
NOTE: Be sure the HIDDEN CAMS in the TOP (E) insert
å
into the LEFT END (B). These two HIDDEN CAMS will be
tightened in Step 9.
NOTE: Be sure the METAL PINS in the LEFT
å
END (B) insert into the SMALL TOP (F),
SMALL TOP BACK (J), and
FRONT PANEL (L) .
L
F
J
Maximum
210 degrees
Minimum
190 degrees
www.sauder.com/services
E
Arrow
G
H
416861
1R
B
Finished edge
B
Page 11
Publicidad
