Publicidad
Step 9
Step
Carefully turn your unit over onto its front edges.
å
Fasten the TOP (E) to the LEFT END (B). Tighten two HIDDEN CAMS.
å
NOTE: The BACK (I) is reversible. Place the color that you want to see
å
inside your unit down.
Unfold the BACK (I) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (I). Push on
å
opposite corners of your unit if needed to make it "square".
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the holes needed.
The perforations are
closer to this edge.
www.sauder.com/services
I
416861
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(41 used in this step)
These holes must line up over
the UPRIGHTS (C and D).
1N
E
B
Tighten the two
HIDDEN CAMS in the
TOP (E) on the inside
of your unit before
attaching the BACK.
Page 13
Publicidad
