Insert Tools, Accessories; Technical Data - Hilti TE 70 Manual De Instrucciones

tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
en

3 Insert tools, accessories

Designation
Hammer drill bits
Breach bits
Percussion core bits
PCM diamond core bits
Chisels
Wood drill bits
Metal drill bits
Designation
TPS Theft Protection System with Company Card,
Company Remote and TPS‑K key
Setting tool
Quick-release chuck
Mixing paddles for non-flammable materials, with
smooth or hex. shank

4 Technical data

Right of technical changes reserved.
Power tool
Weight of power tool
Dimensions (L x W x H)
Power tool
Rated voltage
Rated current input
Mains frequency
Hammer drilling speed
Single impact energy (full power)
Single impact energy (50% power)
4
TE 80‑ATC
10.2 kg (22.49 lb)
555 mm (21.85") x
125 mm (4.92") x 312 mm
(12.28")
TE 80‑ATC
120 V
15 A
60 Hz
380/min
11.5 J
5 J
Description
∅ 12...45 mm (½" to 1¾")
∅ 40...80 mm (1½" to 3¹⁄₈")
∅ 45...150 mm (1¾" to 6")
∅ 42...132 mm (1³⁄₄" to 5¹⁄₄")
Pointed, flat and shaped chisels with TE‑Y connection
end
∅ 10...32 mm (³⁄₈" to 1¼")
Up to ∅ 20 mm (Up to ∅ ¾")
Item number, description
206999, optional
32221, Setting tool with TE‑Y connection end
60208, Keyless chuck for wood and metal drill bits with
smooth or hex. shank, Chuck holder 263359
41215 (∅80mm), 41216 (∅110mm), ∅ 80...150 mm
(3¹⁄₈" to 6"), For use only with the keyless quick-release
chuck
TE 70‑ATC
8.9 kg (19.62 lb)
524 mm (20.63") x
123 mm (4.84") x 294 mm
(11.57")
TE 70‑ATC / TE 70
120 V
15 A
60 Hz
360/min
11 J
5 J
TE 70
7.7 kg (16.98 lb)
524 mm (20.63") x
123 mm (4.84") x 274 mm
(10.79")