Recommended Cutting Equipment For Canada; Bar And Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna 445 Manual De Instrucciones

Recommended cutting equipment for Canada

The following is a list of recommended cutting equipment for chain saws 445, 445e, 450 and 450e. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-04 Chainsaw
Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.

Bar and chain combinations

Bar
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
0,050"/1,3 mm
0,058"/1,5 mm
Saw chain filing and file gauges
32 – English
TECHNICAL DATA
Thickness of drive
links, incH
0,050
0,058
H30 H22
- H25
Max. nose radius
10T
10T
10T
10T
10T
10T
10T
10T
10T
12T
H23
H21
Chain
Type Drive link count
56
64
Husqvarna H30 66
72
78
56
64
Husqvarna H21/
66
Husqvarna H25
72
78
1153136-49 Rev.2 2010-04-08