Recommended Original And Replacement Bar And Chain Combinations; Bar And Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna 435 Manual De Instrucciones

Recommended original and replacement bar and chain combinations

Following is a list of recommended cutting equipment for the Husqvarna chain saw models 435, 435e and 440e. The
combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and
vibration requirements of ANSI B175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Bar and chain combinations

Chain saw models Husqvarna 435, 435e and 440e met the kickback performance requirements of ANSI B 175.1-2000
when tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified
as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000.
We recommend to use only the listed combinations of bars and chains for chain saw models Husqvarna 435, 435e and
440e. Other chain saw models may not meet the kickback requirements when equipped with the listed bar and chain
combinations.
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
Saw chain filing and file gauges
115 13 80-96 Rev.3 2008-12-17
TECHNICAL DATA
Bar
Thickness of drive
links, inch/mm
1,3
Max. nose radius Type
10T
10T
Husqvarna H30
10T
10T
Chain
Drive link count
56
64
66
72
English – 41