Wiring Instructions - Metra 99-7612 Instrucciones De Instalación

Kit Assembly
DDIN radio provision (continued)
4. Mount the Unified Amp Meter to
the radio/bracket assembly using
(2) supplied 3/8" Phillips screws.
(Figure D)
5. Plug the factory harness removed
in disassembly into the 99-7612.
6. Mount the whole DDIN radio/meter
assembly to the radio trim panel
using (4) supplied 3/8" Phillips
screws. (Figure E)
7. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
8. Follow the wiring instructions in
this manual and reassemble dash
in reverse order of disassembly.
(Figure D)
(Figure E)
99-7612

Wiring Instructions

From the included 7612 harness:
1. Plug the black 16-way connector
into the 99-7612.
2. Plug the black 12-way connector
into the 99-7612.
3. Plug the white 16-way connector
into the factory harness.
Driver Information Center Button
Control Note:
The metra kit button layout does
not provide the MAINT or the E/M
buttons from the factory setup. MAINT
button on the 99-7612 is accessed
by pressing the DAY/NIGHT and HOUR
buttons simultaneously. The E/M button
is done by pressing PREV and MIN
simultaneously.
5
Additional 12-pin harness (ASWC-1)
• This 12-pin harness is to be
used in conjunction with the
ASWC-1 (not included). Please
refer to the ASWC-1 instructions
for programming.