Wiring Instructions - Metra 99-7804 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Harnesses Included:
• 24-pin gray Honda connector to 14-pin black interface connector, with
pre-wired 12-pin black ASWC-1/AXSWC harness.
• 24-pin and 12-pin gray Honda connector to 22-pin black interface connector, with a Yellow
female RCA.
• 8-pin gray Honda subwoofer connector to White RCA.
• Blue connector to White connector LVDS cable.
If the vehicle has Bluetooth buttons and you wish to retain them
• Connect the Gray/Blue wire from the ASWC-1/AXSWC to Pin 15 (Lt. Blue) of the Hands Free
Link module's 32 pin connector located below the radio (Touch Screen Models), or
Pin 9 (Lt. Blue) of the 16 pin connector behind the radio.
Connections to be made
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the power antenna wire.

WIRING INSTRUCTIONS

For models with a factory amplifier:
For models without a factory amplifier:
:
(Non-touch screen models)
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Gray RCA jack to the right front RCA output.
• Connect the White RCA jack to the left front RCA output.
• Connect the Green RCA jack to the right rear RCA output.
• Connect the Purple RCA jack to the right rear RCA output.
For the following (8) wires, cut off the RCA jack to expose the speaker wires.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
7
REV. 4/22/2021 INST99-7804

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido