Contents Of The Box; How To Assemble The Nuna Chair - Nuna zaaz Manual De Instrucciones

Contents of the Box
Nuna key
(Harness restraint removal tool)
Tray
Harness restraint 5 pts
Arm bar
Seat cushion
Seat (with flap and height adjustment
lock on reverse side)
Footrest
Leg frame
Tools Needed:
Nuna key to remove harness restraint
when desired (included in the box)
Check that you have all the parts for this product before assembling it.
Refer to the illustrations provided at the beginning of this manual to
identify each part.
8
How to assemble
the Nuna chair
Check that you have all the parts for this product before assembling it.
The assembly should be performed only by adults.
assemble Seat onto leg frame
Once the seat is attached to the legs of the chair, it is considered to be a
permanent assembly. However, it is possible to reverse this assembly if the
seat needs to be put into storage or shipped. We recommend this should
not be a regular occurrence.
1 Place the leg frame on the floor facing you, as illustrated.
2 Take the seat. Release the lock by pulling down the latch at the rear
of the seat flap. Then pull the flap forward completely.
3 Position the seat over the leg frame to line up the slots behind the
seat flap with the white tracks on the leg frame, as illustrated.
4 Once the seat is correctly positioned over the white tracks, keep the
flap up and firmly push the seat downward until you hear a click.
If the flap is not completely up you will not be able to push the seat
down. Continue to push firmly on the sitting surface until the seat
reaches its lowest position.
5 To lock the seat, lower the flap and listen for the click as the lock
clicks back into position.
The seat is now permanently mounted to the legs and can be adjusted
within the range between the highest and lowest positions.
( 1 )
( 2 )
( 3 )
9