Shindaiwa T272 El Manual Del Propietario página 7

Assembly and Adjustments
Cutting Attachment Shield
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Retaining
23105
Nut
Figure 8
Install the Cutting Attachment
Shield T272/T272X.
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment shield mounting plate.
See Figure 8.
NOTE:
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting attach-
ment shield mounting plate.
2. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head cap screws. See
Figure 8.
3. Tighten the four socket-head cap screws
to secure the cutting attachment shield.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
To Change Position of Line Cutter.
The line cutter can be positioned in
2 positions to obtain different line length
for cutting.
1. Remove the 2 hex screws with a 4mm
hex wrench. See Figure 8A.
2. Rotate line cutter. See Figure 8A.
3. Reinstall the two hex screws and tighten
them securely.
Outer
Tube
Shim
Cutting
Attachment
Shield
Hex
Mounting
Screws
Plate
Figure 8A
WARNING!
NEVER operate the unit without the
cutting attachment shield installed and
tightly secured!
Bracket
Sub-Shield T272X.
(when trimmer head is in use)
1. Attach the shield extension to the
cutting attachment shield.
WARNING!
NEVER use this machine without
sub-shield when using a trimmer
head.
WARNING!
The line cutter is very sharp. Wear
gloves to protect your hands when
handling.
Be careful to not lose the 2 nuts in the cutting
attachment shield, they are not captured.
T272
Cutting
Attachment
Shield
Nuts
Line Cutter
NOTE:
Bolt
Upper Clamp
Shim
Shim
Nut
Cutting Attachment Shield
Cutting Attachment Shield
Sub-shield
CAUTION!
Make sure the sub-guard is completely
hooked at the hook receiver.
T272X
Hook
Receiver
Hook
7