Assembly - Shindaiwa T272 El Manual Del Propietario

Assembly and Adjustments
Handle T272/T272X
The handle is attached to the outer tube on
the T272/T272X.
To Adjust the Handle.
1. Loosen the 4 socket-head cap screws on
the handle. See Figure 5.
2. Position the handle forward of the Han-
dle Positioning Label at the best position
for operator comfort (usually about 10
inches ahead of the throttle housing).
3. Secure the handle by alternately tighten-
ing the four socket-head cap screws in a
diagonal or "crisscross" fashion.
Adjusting Throttle Level Free Play T272/T272X
The throttle lever free play should be ap-
proximately 9/32 inch (7mm). See Figure 6.
Make sure that the throttle lever operates
smoothly without binding. If it becomes
necessary to adjust the lever free play,
follow the procedures and illustrations that
follow.
1. Loosen the lock nut on the cable
adjuster. See Figure 7.
2. Turn the cable adjuster in or out as re-
quired to obtain proper free play of 9/32
inch (7mm). See Figure 7.
3. Tighten the locknut.
6
4 Socket-head
Cap Screws
Figure 5
T272X
Figure 6
Handle
Outer Tube
Barrier
Bar
Locknut
�����
9/32 inch
(7 mm)
Throttle Lever
Adjuster
Free Play
Figure 7
Handle Positioning Label
T272X Shown
Cable