Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24

After use

Warning: Never touch the steam head until it
cools completely.
• After using the steamer, switch the power off
(power indicator light will go out) and unplug
the appliance.
• Remove the steam hose
Be careful, hot water may remain in the
steam hose. Always remove the steam hose
before emptying your appliance.
• Empty the water container
• Wrap the hose around the steamer and insert
the steam head on its housing
• Wind the power cord on its storage place
under the appliance
-
• You can carry your steamer by its handle
fig.15.
Empty all water from the unit before storing it.
For cord winding or transport, never turn
your appliance upside down.
IS THERE A PROBLEM ?
Problems
There is no steam.
There is little steam.
Water runs through the holes
of the steambrush.
The steamer takes a long
time to heat.
For any product problems or queries, please visit our website - www.rowenta.co.uk
or contact our Helpline on 0845 602 1454 - UK (01) 461 0390 - Ireland
-
fig.1.
-
fig.12.
- fig.13
and 14.
fig.2.
Possible causes
The garment steamer is not
turned on.
The water level is too low.
The hose is kinked.
There is no more water.
Your steamer has a build-up of
scale because it has not been
rinsed out regularly.
The water level is too low.
There is too much water.
There is condensation in the
hose.
Your steamer has a build-up of
scale because it has not been
descaled regularly.
There is too much water.
Cleaning
Clean the main unit using a damp cloth. To
maintain maximum performance, your steamer
must be descaled occasionally. The descaling
intervals will depend on the water quality and
the frequency of use.
The unit should be descaled at least once a year
or every 100 hours of use.
For descaling proceed as follows:
1. Unplug the unit and fill it with 1/3 white
vinegar and 2/3 water.
2. Let the appliance run for 3 minutes and do not
steam any clothing with this mixture.
3. Switch the appliance off. Unplug it and allow
to cool down for at least 30 minutes.
4. Pour the mixture over the sink. Rinse the
appliance with fresh water.
-
If after descaling you believe that there is still
a buildup in the appliance, repeat this
operation. Use a new solution of vinegar and
water each time you repeat steps 1 and 2.
Solutions
Check that your appliance is correctly plugged in
and press the illuminated on/off switch (on the
front of the base-unit).
Turn your appliance off and refill it.
Be sure that the hose is fully unravelled.
Unplug your steamer and refill it.
Descale the steamer at least once a year or after
every 100 hours of use. If your water is hard,
increase the frequency.
Turn your appliance off and refill it.
Unplug your steamer and empty the excess
water.
Never use steamer in a horizontal position.
Hold the hose vertically and wait for water to
flow back into the steamer.
Rinse out the steamer at least once a year or
every 100 hours of use. If your water is hard,
increase the frequency.
Unplug your steamer and empty the excess
water.
GB
7

Publicidad

Tabla de contenido
loading

Tabla de contenido