After Use; Maintenance And Cleaning - Rowenta ADVANCER DZ9050U5 Manual De Instrucciones

1103902648 DZ9000 D1
13 • Automatic electronic 3-position shut off*
If, although switched on, the appliance is not moved, it will
automatically switch off and the auto off light will flash after the
following intervals (fig.17):
- After 30 sec., if the iron is left placed down on the soleplate or
lying on its side.
- After 8 mins., if the iron is left standing on its heel.
- To switch the iron back on move the iron gently.

AFTER USE

14 • Emptying
Unplug the iron (fig.4), pour away remaining water
steam control to
Open and close the steam control several times
the drip hole into the steam chamber from furring or blocking up.
15 • Storing
IMPORTANT Do not wind the cord around the hot soleplate.
Never store your iron placed down on the soleplate (fig.20).
Allow the appliance to cool down before storing the iron standing
on its heel (fig.20).

MAINTENANCE AND CLEANING

IMPORTANT Unplug and allow the iron to fully cool down
before maintenance and cleaning.
16 • Anti-scale system
Your iron contains an anti-scale cartridge to reduce scale deposits.
This considerably prolongs the operational life of your iron.
The anti-scale cartridge is an integral part of the water tank and
does not need to be replaced.
IMPORTANT Do not use descaling agents, as these damage the
lining of the steam chamber and so may impair the steam function.
17 • Self Clean function
(prolongs the life of the iron)
The Self Clean function flushes dirt and scale particles out of the
steam chamber. Fill the water tank with untreated tap water up to
the max mark and heat the iron to the ••• temperature.
* depending on model
7/11/07 16:26
.
6
Page 6
(fig.18) and set
(fig.19) to prevent