Specifications; Assembly - Shindaiwa T272 Manual Del Operador

Specifications T272X/C272
Engine Code .................. S272E Engine
Dr y weight, T272
(less attachment) ............ 6.7kg/
Dr y weight, T272X
(less attachment) ............ 6.7kg/
Type .............................. 2-cycle, vertical cylinder, air
Bore x Stroke ................. 34 mm x 30 mm/
Displacement ................. 27.2cc/
Maximum Power Output . 1.1 kw/
Operating rpm Range ..... 4,500-9,000 rpm (min
Transmission Type ......... Automatic centrifugal clutch
Fuel/Oil Ratio ................ 50:1 with ISO-L-EGD or JASO
* Shindaiwa One meets or exceeds these specifications and is recommended for all Shindaiwa Products
** The EPA emission compliance referred to on the emission compliance label located on the engine, indicates the number of operating hours for
which the engine has been shown to meet Federal emission requirements. Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A =
300 hours (Extended).
This unit comes fully assembled with
the exception of the cutting attach-
ment shield and cutting attachment.
Prior to Assembly
Before assembling, make sure you
have all the components required for
a complete unit and inspect unit and
components for any damage.
Assembly and Adjustments
Handle T272/T272X
The handle is attached to the outer tube
on the T272/T272X.
To Adjust the Handle.
1. Loosen the 4 socket-head capscrews on
the handle. See Figure 5.
2. Position the handle forward of the
Handle Positioning Label at the best
position for operator comfort (usually
about 10 inches ahead of the throttle
housing).
3. Secure the handle by alternately tight-
ening the four socket-head cap screws
in a diagonal or "criss-cross" fashion.
14.7 pounds
14.8 pounds
cooled
1.3 in. x 1.2 in.
1.7 cu. in.
1.4 hp
)
-1
through bevel gears
FC class 2-cycle mixing oil*
n Engine and shaft assembly
n Cutting attachment shield
n Cutting attachment
n Kit containing cutting attachment
shield bracket and hardware, this
owner's/opertor's manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a hex
wrench set, spark plug/screwdriver
combination wrench and a spanner.
4 Socket-head Cap-
screws
Figure 5
Fuel Tank Capacity ......... 670ml/
Carburetion ................... Walbro diaphragm-type
Ignition ......................... Fully electronic, transistor
Spark Plug .................... Champion CJ8Y
Air Cleaner Type ............ Non-reversible heavy-duty
Starting Method ............. Recoil
Stopping Method ............ Slide switch, grounding type
Handle .......................... Loop handle (T272)
Loop handle with barrier bar
EPA Emission Compliance Period**
The terms "left," "left-hand," and "LH":
"right," "right-hand," and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation of this
product.
Handle
Handle Positioning Label
Outer Tube
Barrier
Bar
22.6 ounces
controlled
filter element
(T272X)
Categor y A
IMPORTANT!
T272X Shown
5