Troubleshooting Guide - Eaton LUMARK Crosstour MAXX Instrucciones De Instalación

Installation Instructions - Crosstour MAXX Emergency Egress Option
POLE MOUNT INSTALLATION
1. Unscrew door with Phillips screw driver. Remove door
from back box.
2. Remove the pole top cap.
3. Hold the nut plate on the inside of the pole and insert
the threaded rods through the pole and tighten into
the nut plate. Assure that the mounting bolts are
completely threaded through the nut plate (Figure 5).
4. Slide the arm over the threaded rods. Ensure the drain
hole on the arm is on the bottom side and facing the
pole.
For installation to round poles, place round pole
N ote:
adaptor between the arm and pole.
5. Install back box on the threaded rods and place washer,
lock washer, and nut on each mounting bolt.
6. Tighten both nuts inside the back box to 40 ft-lbs. using
a 3/4" socket.
7 . Route the pole supply wiring through the arm and into
the back box through the center hole.
8. See steps 5-8 under electrical connections.
TROUBLE SHOOTING GUIDE
If emergency LEDs or indicator LED does not illuminate,
check the following:
1. Check AC supply – verify that the unit has a 24 hour AC
supply.
2. Unit is shorted, battery is not connected, or test button
not connected.
3. Battery discharged. Permit unit to charge up to 7 days
and re-test.
4. If following the above trouble shooting guide does
not solve your problem. Contact your local lighting
representative at Eaton for assistance.
4
EATON
IB514002EN Installation instructions
(2) Lock Washers
(2) Washers
Nut Plate
(2) Threaded
Rods
Round
Pole
Adapter
(Optional)
Figure 5.
(2) Nuts
Arm
Drain
Hole
(Bottom View)