Electrical Connections - Eaton LUMARK Crosstour MAXX Instrucciones De Instalación

ELECTRICAL CONNECTIONS

1. Over Junction Box: Make supply wiring connections to
the backside of the wire-way cover plate. Follow NEC
guidelines for wet location wiring (wire nuts supplied by
others). Ensure all wires are secured in the junction box
and re-install wire-way cover plate by rotating clockwise
into the screws. Tighten wire-way cover plate screws to
10 in-lbs. (Figure 2).
Thru-Branch Conduit: Remove the required 1/2" NPT
conduit plug(s). Apply sealing compound or Teflon
tape to liquid-tight conduit fitting (supplied by others)
entering back box to create water-tight seal. DO NOT
remove the wire-way cover plate (Figure 2). Remove
wire leads from the wire-way cover plate by gently
pulling the wiring located in the black grommet toward
you. Do not remove black grommet from the wire-way
cover plate.
Back Conduit Entry: Remove the black grommet and
wires from the wire-way cover plate (DO NOT remove
circular gasket). Attach conduit to wire-way cover
plate with water-tight connector (supplied by others).
Re-install wire-way cover plate by rotating clockwise
into the screws. Tighten wire-way cover plate screws to
10 in-lbs. (Figure. 2).
2. Secure door into lock hinges located at the top of the
back box (Figure. 4).
3. For emergency battery pack connection, wire the
unswitched line to the labeled leads on the emergency
driver. Utilize Push-in connectors to make fixture wiring
connections (see wiring diagrams).
4. Connect the battery connector and egress test button
connector. The egress LEDs should illuminate once the
battery connector is connected.
5. Ensure all electrical wires and connections are secured
in the back box, re install door and tighten door screw
to 15-20 in-lbs.
Installation Instructions - Crosstour MAXX Emergency Egress Option
Figure 2.
Figure 3.
Figure 4.
SEE INSTRUCTION FOR
CONDUIT APPLICATION
THIS SIDE IN FIXTURE
SEE INSTRUCTION FOR
CONDUIT APPLICATION
Black
Grommet
5-5/8"
2-13/16"
2-1/2"
Access Outlet Box
Locking Hinges
Push-in
Connectors
EATON
IB514002EN Installation instructions
Battery Pack
(2) Cover
Plate Screws
Black
Grommet
Wire-Way
Cover Plate
Test Button
Circular
Connectors
Gasket
(Back view)
(4) Mounting
Holes
5"
Test Button
3