Replacing The Light Bulb; Exhaust Feature - GE CVM1790 Manual Del Usuario

Replacing the Light Bulb

Cooktop Light/Nite Light
Replace with a 120 volt, 40 watt (max.) halogen bulb.
Order WB08X10051 from your GE supplier.
1. To replace the cooktop light/nite light, first disconnect
the power at the main fuse or circuit breaker panel, or
pull the plug.
2. Remove the screw from the side of the light
compartment cover and lower the cover until it stops.
3. Be sure the bulb is cool before removing. Break the
adhesive seal by gently unscrewing the bulb.
4. Screw in the new bulb, then raise the light cover and
replace the screw. Connect electrical power to the
oven.

Exhaust Feature

Vent Fan
The vent fan has two metal reusable vent filters.
Models that recirculate air back into the room also use
a charcoal filter.
Reusable Vent Filter
The metal filters trap grease released by foods on the
cooktop. They also prevent flames from foods on the
cooktop from damaging the inside of the oven.
Removing and Cleaning the Filters
To remove, slide them to the rear using the tabs. Pull
down and out.
To clean the vent filters, soak them and then swish
around in hot water and detergent. Don't use ammonia
or ammonia products because they will darken the metal.
Light brushing can be used to remove embedded dirt.
Rinse, shake and let dry before replacing.
49-40773-2
Remove screw.
Charcoal filter (on some models).
Reusable vent filters
(on all models).
the hood is used. The vent filters should be cleaned
once a month, or as needed.
To replace, slide the filters into the frame slots on the
back of each opening. Press up and to the front to lock
into place.
25