HumanTechnik lisa Instrucciones De Servicio página 8

To change the flash duration for
a particular transmitter, remove
the transmitter from the mains
socket and, while pressing in
the Personal Call button, plug
the transmitter back into the
socket. To switch back to 28
seconds remove the transmit-
ter from the socket and plug
back in again this time without
pressing the Personal Call but-
ton.
Telephone connection
Plug the transmitter into a con-
venient mains socket. Plug the
end of the cable with the trans-
parent clip-in connector (6-pin
plug) into the socket at the
underside of the transmitter.
Plug the other end into the
telephone socket.
If the required telephone sok-
ket is in use plug a 3-way tele-
phone adaptor into the socket
and plug your telephone into
one of the sockets on the
adaptor.
Warning:
Only use the supplied telepho-
ne cable otherwise correct ope-
ration can not be guaranteed.
The Telephone Transmitter -
Galvanic is only designed for
connection to analogue
systems. If a connection is
required to a digital system
(e.g. ISDN or part of a PBX
exchange system) please use a
Telephone Transmitter -
Acoustic.
Important note
All lisa devices connected to
the mains supply have a low
power consumption which may
lead to the device feeling
warm. This is normal and does
not interfere with the normal
function of the devices.
These signalling systems have
a high operational safety.
Should any faults occur in spite
of proper installation and use,
please contact your dealer.
High and low voltage spikes
(e.g. during a thunderstorm)
can occur on the mains supply.
The lisa devices have an inte-
grated electronic controller
which may stop working after
these conditions. If this hap-
pens simply unplug each of the
devices and plug them in again.
As a precaution remove all
devices from their sockets
during a thunderstorm.
English - 8