Safety Recommendations - Equipment - Pecol V20 Brushless RBPROHP Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.3. Safety Recommendations - Equipment

• Disconnect the machine from the battery before any intervention.
• Select the correct power tool taking into account the type of use and power required.
• Do not change or make adjustments that change the original configuration of the
power tool.
• Use only recommended and quality discs (see page 66).
• Check if the disc is in good condition, without defects.
• If you intend to cut wood, use specific wood discs, which are designed for use on angle
grinders.
Never adapt a circular saw disc (I) or a disc with chains (II)
for wood, on a grinder. Risk of serious injury.
• Always operate with the protective guard and positioned to protect the user.
• Always use the auxiliary handle. This will give more control and safety to the use.
• Check the general condition of the battery. Look for cracks, clearances, loose parts
inside, among others. If liquid is spilled from the inside of the structure, insulate the
battery to avoid contact with skin or local contamination and refer to PECOL Technical
Assistance Service.
• The battery's electrolytic liquid is highly alkaline and corrosive. In case of contact
with the skin or eyes, rinse immediately with plenty of water and seek medical advice
at the earliest opportunity. If the battery emits vapours, remove from the environment
immediately, ventilate the area and seek immediate medical attention.
• In case of battery, charger or power tool fire, use only chemical or CO2 extinguisher.
• Inspect the cables of extensions, charger and plugs for cracks, dry parts, insulation,
and keep them clean and free of oils and greases, which can deteriorate the insulation.
• Only use certified cables and plugs with EC marking and with supported power (in
watts) greater than the sum of all equipment connected to it.
• Never pull the plug or hold the charger by the cable.
• If the part is small or can move, always use tightening clamps (A), a bench lathe (B) or
grip pliers (C) to secure it.
P.54
PT
ES
B
A
EN
FR
I
C
II

Publicidad

Tabla de contenido
loading

Tabla de contenido