Deburring And Thinning Operation - Pecol V20 Brushless RBPROHP Manual Del Usuario

3.9. Deburring and thinning operation

• When powering up, wait until the machine reaches maximum speed before starting
work.
• Tilt the angle grinder according to the needs of the work, within the recommended
angles. Make sure that the workpiece is securely fastened.
• Do not apply too much pressure. A decrease in rotation worsens the result and the
efficiency of the roughing work. Do not generate excessive heat on the disc and the part.
Make stops.
• Hold the grinder firmly and, with proper posture, apply circular movements back and
forth.
• Always use both hands, and with the auxiliary handle installed.
If, despite maintaining the correct tilt, the work starts having poor performance, it is a
sign that the disc is worn out or a higher power is required.
Wait for the machine to immobilize the movement before lowering or put it down.
Pay attention to the power cable so that it is not damaged by sharp edges in the work
area or by the operating grinder itself.
• Never use any liquids to perform works with this power tool.
• Do not obstruct the air vents of the machine.
• Disconnect the power tool from the battery at the end of the operation.
Never use the shaft lock button or rest the disc on a surface to stop the movement
faster.
Never touch the disc immediately after the operation as it may be hot.
If the machine is subjected to heavy and long-term use, excessive heating and activation
of the thermal protection system of the battery is possible, causing a deceleration of
the machine or even a temporary stop. In this situation, wait for the batteries to cool to
resume operation
P.60
PT ES EN FR