OPERATION
Control elements
Remote control
1. Plug in and switch on by pressing the red switch 0/I, enter into standby
mode and display shows„5".
2. Press
. " button for one time, enter into fan mode and the display show
"--"
Press second time , the product works with low heating(1000 W) and
display shows „--/ ".
Press third time, changes to high heating(2000 W) and display shows
„--/".
press fourth time , enter into swing and display shows „--/
Press fifth time , change to stand by.and display shows „--".
3. Press
button to set timer(00-12 hours). Pressing the button one time
increases one hour for timer. After setting time, the display will show
current setting time for 5 seconds, then resume to previous display,
meanwhile the light of
8h.
Control panel
will on. Below photo is an example of setting
".
EN
19