oneConcept 10033139 Manual De Instrucciones página 21

For example: Setting to Wednesday, 9:30 AM under 25 °C under II heating,
please refer to the following photos.
Note:
• Press SET to check the current time & day in turn;
• The LCD was display off if no any operation during 5 seconds;
• The timer is in 24 hours.
• 00~59 minutes.
Set temperature
• During working status, Press */- , the display shows " 23 " as default.
• Press +/- to set desired temperature (temperature range 10-49 °C), press
OK to confirm the setting.
When setting temperature, it will use SMART working way
For example: The current ambient temperature is 15 °C, when set
temperature to 25 °C, the display shows as below:
1. Setting temperature – ambient temperature>2 °C, working with high
power-2000 W.
2. 0 °C<Setting temperature – ambient temperature=<2 °C, working with
low power-1000 W.
3. Setting temperature – ambient temperature=0 °C. The cool fan will
work for 30 seconds to below out the heating left inside, then enter into
standby mode.
4. After enter into standby mode, if the machine cool down.
5. Setting temperature – ambient temperature>=2 °C, the machine will
wake up and resume to heating.
If you want to cancel the setting temperature, press
heating or . The product will work without setting temperature. While
the display "°C" will go off, and will show "--". "--". After continuous heating for
12 hours, the cool fan will work for 30 seconds and enter into standby mode.
key to choose the
EN
21