Attaching The Fan Blades - HAMPTON BAY Sibley 52-BRW Manual Del Propietário

CLOSE-TO-CEILING MOUNTING
1. Carefully unhook the fan from the mount-
ing bracket and align the locking slots of
the ceiling canopy with the two screws in
the mounting plate. Push up to engage the
slots and turn clockwise to lock in place. Im-
mediately tighten the two mounting screws
firmly.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE EN-
GAGED AND FIRMLY TIGHTENED.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by align-
ing the ring's slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
4. You may now proceed to attaching the fan
blades.
8.
Attaching the
Fan Blades
Your fan features revolutionary advancements
for quick and easy blade installation
1. Mount the fan blades to the pre-installed
blade brackets by aligning the three key-
hole slots in the blade with the three posts
on the top of the blade bracket (Figure 14).
2. Hold the blade with both hands close to
the blade bracket and press the blade down
firmly. Ensure the key-slot holes are prop-
erly seated on the blade bracket posts.
3. While still holding the blade down with both
hands, firmly slide the blade away from the
motor assembly until the blade engages in
the locking mechanism. Make sure the steel
locking mechanism at the rear of the blade
bracket springs upward and butts against the
edge of the blade indicating a secure con-
nection (Figure 15).
4. Visually inspect the top of the blade bracket
to ensure that the locking mechanism is se-
curely in place.
5. Repeat for the remaining blades.
FAILURE TO PROPERLY SEAT THE BLADES
ON THE BLADE BRACKETS AND ENGAGE THE
LOCKING MECHANISMS COULD RESULT IN
THE FAN BLADES LOOSENING AND POSSIBLY
FALLING.
Figure 14
Figure 15