INDOOR UNIT
• Switch off the power supply and unplug before cleaning.
• Do not touch the aluminium fi n, sharp parts may cause injury.
CAUTION
CLEANING INSTRUCTIONS
CLEANING INSTRUCTIONS
• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
4
2
5
7
6
1
INDOOR UNIT
• Wipe the unit gently with a soft, dry cloth.
2
FRONT PANEL
Remove Front Panel
• Raise and pull to remove the front panel.
• Wash gently and dry.
Close Front Panel
1
2
1
1 Press down both ends of the front panel to close it.
2 Press at center of the front panel to close it securely.
(CS-S18NKZW, CS-S24NKZW, CS-S28NKZ)
SUNLIGHT SENSOR AND REMOTE CONTROL
3
RECEIVER
4
ALUMINIUM FIN
5
HUMAN ACTIVITY SENSOR
6
HORIZONTAL AIRFLOW DIRECTION LOUVER
• Do not adjust by hand.
HINT
HINT
• To ensure optimal performance of the unit, cleaning
maintenance has to be carried out at regular intervals.
Dirty unit may cause malfunction and you may see error
code "H99". Please consult authorized dealer.
1
5
HUMAN ACTIVITY SENSOR
8
• Do not hit or violently press the sensor or
poke it with a sharp object. This can lead to
damage and malfunction.
• Do not place large objects near the sensor
9
and keep away heating units or humidifi ers
from the sensor's detection area. This may
lead to sensor malfunction.
10
nanoe-G GENERATOR
3
• Do not touch during operation.
7
VERTICAL AIRFLOW DIRECTION LOUVER
• Do not adjust by hand.
8
AUTO OFF/ON BUTTON
• Use when remote control is misplaced or a malfunction
occurs.
Action
Press once.
Press and hold until 1 beep is
heard, then release.
Press the button to turn off.
9
AIR FILTERS
• Air fi lter cleaning is required every two weeks.
• Wash/rinse the fi lters gently with water to avoid damage
to the fi lter surface.
• Dry the fi lters thoroughly under shade, away from fi re or
direct sunlight.
• Replace any damaged fi lters.
10 nanoe-G GENERATOR
Clean with dry cotton bud.
• nanoe-G generator cleaning is
recommended every 6 months.
Mode
Auto
Cooling
9