Maintenance Of The Unit - BaByliss Brushing 700 Manual Del Usuario

sections underneath. Sections
should be a maximum of 2cm
wide and as even as possible.
Using the 38mm rotating head
• To prepare the section and to
untangle, lift the roots of the
small section and straighten
the section, with the unit set to
hot, in one or two strokes but
without turning the brush; (1)
• Hold the section of hair at a 90° an-
gle to your head so that the hair un-
derneath doesn't get tangled; (2)
• Slide the brush over the sec-
tion while turning the brush,
but not completely, repeat sev-
eral times while sliding the brush
from the roots to the tips; (3)
• Finish with a full turn of the sec-
tion around the brush from
roots to tips, hold a few sec-
onds so that the section is com-
pletely heated and shaped and
so that the roots are lifted; (4)
• Repeat the operation if neces-
sary, according to your hair type;
• Don't forget the shot of cool air at
the end for a long-lasting set. To
do this, use the cool-air shot with-
out turning the rotating head.
Blow-drying outwards
Place the brush under the sec-
tion at the tips of your hair,
and start the automatic rota-
tion to turn outwards. (5) + (6)
Blow-drying under
Place the brush under the sec-
tion at the tips of your hair,
and start the automatic rota-
tion to turn under. (7) + (8)

MAINTENANCE OF THE UNIT

• Unplug the
allow to cool
before cleaning or storing.
• We advise you clean the brush
regularly to avoid build-up of hair,
styling products, etc. Use a comb
to remove hair from the brush.
Use a dry or very slightly damp
cloth for the plastic surfaces.
• Caution! When you have finished
using the rotating head, do not
place it, as is, on the support,
you risk damaging and bending
the bristles. Store it in the case
intended for
6
unit and
completely
this purpose.