Sanus SMF3 Manual De Instrucciones página 13

3. Drill pilot holes and remove wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
16
4. Install wall plate using lag bolts
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
3
15
.
17 19
and washers . Tighten the lag bolts only until the washers are pulled firmly against the wall plate.
75 mm
(3 in.)
5.5 mm
(7/32 in.)
15
4
16
19
17
13