Descargar Imprimir esta página

Publicidad

Enlaces rápidos

SLT 3
INSTRUCTION MANUAL
We'll Make It Stress-Free
If you have any questions along the way, just give us a call.
1-888-333-1376 We're ready to help!

Publicidad

loading

Resumen de contenidos para Sanus SIMPLICITY SLT3

  • Página 1 SLT 3 INSTRUCTION MANUAL We’ll Make It Stress-Free If you have any questions along the way, just give us a call. 1-888-333-1376 We’re ready to help!
  • Página 2 No — Perfect! (including accessories) wood studs, solid 150 lb weigh MORE than? Yes — This mount is NOT compatible. Visit Simplicity.Sanus.com or call concrete, and (68.0 kg) 1-888-333-1376 to fi nd a compatible mount. concrete block walls: No — Perfect!
  • Página 3 Do you have all the tools needed? 1/2 in. (13 mm) Tape Measure Pencil Level Screwdriver Electric Drill Socket Wrench 7/32 in. 1/2 in. 3/8 in. (5.5 mm) (13 mm) (10 mm) Wood Steel Stud Concrete Drill Bit Drill Bit Stud Finder Drill Bit Hammer...
  • Página 4 Dimensions in. [mm] TV INTERFACE 23.62 600.0 7.87 200.0 0.34 16.93 430.0 WALL PLATE FEATURES 100x100 VESA PATTERN 3.94 12° 27.00 100.0 685.9 5° 24.00 KNOBS 609.6 16.00 406.4 0.33 22.86 580.7 KNOBS ONLY TO FACE EACH OTHER IF THE TV MOUNTING PATTERN 7.10 2.87 IS 100mm x 100mm...
  • Página 5 Supplied Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer;...
  • Página 6 Parts and Hardware for STEP 2 Lag Bolts 5/16 x 2¾ in. Lag Bolt Washer Wall Plate Template 5/16 in. For concrete installations ONLY CAUTION : Do not use in drywall or wood Concrete Anchors Fischer UX10 x 60R Wall Plate Fischer UX10 x 60R...
  • Página 7 Hardware for STEP 2C (not included) Hardware for STEP 3 Steel Stud Anchor Kit #SSMK1 (not included) Contact Customer Service at 1-888-333-1376 t o inquire about the additional hardware. Hex Key 1/4-20 Snap Toggle BB S1 x4 Securement Screw M5 x 25mm 1/4-20 x 1¾...
  • Página 8 STEP 1 Attach Brackets to TV If your TV included inset spacers or wall mount adapters, see Troubleshooting 1.1 Select TV Screw Diameter 1.2 Select TV Screw Length on PAGE 23. Hand thread screws into the threaded : If your TV has a flat : Spacers and longer screws are inserts on the back of your TV to back AND you want your...
  • Página 9 1.3 Attach Brackets to TV Center the TV brackets over your TV hole pattern as shown - making sure the brackets are level. IMPORTANT: tilt tension knob TV brackets should normally be oriented to the outside edges, EXCEPT for TVs with 100 mm (4 in.
  • Página 10 Minimum wood stud size: nominal 51 x 102 mm (2 x 4 in.) actual 38 x 89 mm (1 ½ x 3 ½ in.) HeightFinder ™ at SANUS.com/2665 ● Minimum horizontal space between fasteners: 406 mm (16 in.) Locate studs. Verify the center of the stud(s) using an awl, a thin nail, or an edge to edge stud finder.
  • Página 11 Drill pilot holes then remove the wall plate template IMPORTANT: Be sure to drill into the center of the stud. IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm), using a 7/32 in. (5.5 mm) diameter drill bit. Install the wall plate using four lag bolts and washers...
  • Página 12 ● Minimum solid concrete thickness: 8 in. (203 mm) HeightFinder ™ at SANUS.com/2665 ● Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm) ● Minimum horizontal space between fasteners: 24 in. (610 mm) Level the wall plate template and mark the hole locations.
  • Página 13 Remove the wall plate template and insert concrete anchors CAUTION: Be sure the anchors are seated flush with the concrete surface. Install the wall plate using four lag bolts and washers . Tighten all lag bolts only until they are pulled firmly against the wall plate. CAUTION: Improper use could reduce the holding power of the lag bolt.
  • Página 14 Attach Wall Plate Steel Stud Installation STEP 2C Steel Stud Anchor Kit (not included) - Contact Customer Service at 1-888-333-1376 t o inquire about the additional hardware. 1/4-20 x 1¾ in. 1/4-20 Snap Toggle BB 1/4 in. S2 x4 S1 x4 S3 x4 CAUTION: Avoid potential personal injuries and property damage!
  • Página 15 2 4 i n . ( 6 0 9 m 1 6 i n . ( 4 0 6 m 1 in. (25 mm) NOTE: For assistance in 1/2 in. determining wall plate location, try our (13 mm) HeightFinder ™ at SANUS.com/2665...
  • Página 16 Insert snap toggle anchors by folding metal channel until it is flat with the plastic straps. Slide the metal channel into the drilled hole. Hold the plastic straps by the end and pull towards you until the metal channel is flush behind the drywall.
  • Página 17 Slide the plastic cap down the straps and into the hole with the lip of the cap flush against the wall. Bend the straps side to side until they snap off level with the lip of the cap.
  • Página 18 Install the wall plate using four screws and washers . Tighten all screws only until they are pulled firmly against the wall plate CAUTION: Improper use could reduce the holding power of the screws . DO NOT over-tighten the screws 2 4 i ( 6 0 1 6 i...
  • Página 19 STEP 3 Hang TV onto Wall Plate HEAVY! You may need assistance with this step. Install the TV / Bracket assembly by fitting the top hooks of BOTH TV brackets over the top edge of the wall plate TIP: Tilt TV brackets as shown for ease of installation.
  • Página 20 Swing the TV/mounting brackets down until they rest against the wall plate . Install securement screws to secure arm to wall plate IMPORTANT: BEFORE MOVING YOUR TV, securely tighten down screws to properly install the assembly. CAUTION: Avoid potential personal injuries or property damage! Screws must be installed to secure arms to wall plate Periodic tightening may be required.
  • Página 21 Adjustments LEVEL TILT EXTEND / RETRACT Your TV should adjust easily when moved, then stay in place. If your TV is too loose or too tight, adjust side If your TV doesn't extend or retract tension knobs properly, remove your TV (See PAGE 22), then reinstall following STEP 3 on NOTE: Once your TV is in place, tighten the side PAGE 19.
  • Página 22 REMOVING THE TV TV LATERAL SHIFT Remove your TV BEFORE shifting side-to-side: Loosen screws to remove your TV from the wallplate. Rehang your TV on the wallplate where desired (STEP 3). Reinstall your TV and screws (STEP 3).
  • Página 23 Troubleshooting If you are uncertain about your hardware selection, TV Supplied contact Customer Service at 1-888-333-1376. TV supplied spacers Spacers : Use your TV supplied spacer and spacer for: : Use your TV supplied spacer for flat back TVs (AND you want your TV closer to the wall).
  • Página 24 68.0 kg montantes de madera, (incluidos los accesorios) 49.8 kg Sí — Este soporte NO es compatible. Visite MountFinder.Sanus.com o hormigón macizo y pesa más de? montantes (150 lbs.) (110 lbs.) llame al 1-888-333-1376 para encontrar un soporte compatible.
  • Página 25 ESPAÑOL Dimensiones ver página 4 Piezas y elementos de montaje suministrados ver página 5 ADVERTENCIA: Este producto contiene piezas pequeñas que, en caso de ser tragadas, podrían causar asfixia. Antes de comenzar a montar la unidad, verifique que dispone de todas las piezas y que se encuentran en buen estado. Si no dispone de todas las piezas o alguna está dañada, no devuelva el elemento defectuoso al distribuidor. Póngase en contacto con el Servicio de Atención al Cliente.
  • Página 26 ESPAÑOL PASO 1 Fijar el soporte al televisor ver página 8 1.1 Seleccione el diámetro de los tornillos del televisor Enrosque manualmente los tornillos en los orificios roscados de la parte posterior del televisor para determinar el diámetro correcto del tornillo (M4, M6 o M8) que debe usar. 1.2 Seleccione la longitud de los tornillos del televisor : Si su televisor tiene la parte trasera plana Y desea que esté...
  • Página 27 ● Tamaño mínimo de los montantes de madera: nominal 51 x 102 mm (2 x 4 pulg.) actual 38 x 89 mm (1½ x 3½ pulg.) ™ SANUS.com/2665 nuestro Height Finder ● Espacio mínimo entre los elementos de sujeción: 213,4 mm (8,40 pulg.) ●...
  • Página 28 ● Grosor mínimo del hormigón macizo: 203 mm (8 pulg.) ™ SANUS.com/2665 nuestro Height Finder ● Tamaño mínimo del bloque de hormigón: 203 x 203 x 406 mm (8 x 8 x 16 pulg.) ●...
  • Página 29 NOTA: Si necesita ayuda para determinar la ubicación de la placa ● El televisor y los accesorios no deben pesar más de 49.8 kg (110 lb) ™ SANUS.com/2665 de pared, consulte nuestro Height Finder ● Los montantes deben tener al menos 2 x 4 pulgadas / 25 ga. de grosor ●...
  • Página 30 ESPAÑOL PASO 3 Colgar el televisor en la placa de pared ver página 19 ¡PRODUCTO PESADO! Podría necesitar ayuda para realizar esta operación. Instale el montaje del soporte del televisor; para esto, encaje los enganches superiores de los soportes del montaje sobre el borde superior de la placa de pared Pivotar los soportes de montaje hacia abajo hasta que se apoyen en la placa de pared pared...
  • Página 31 Solución de problemas ESPAÑOL ver página 23 Si no está seguro acerca de cuáles son las herramientas que debe utilizar, póngase en contacto con el Servicio de Atención al Espaciador Espaciadores suministrados Cliente al 1-888-333-1376. con el televisor : Use el espaciador suministrado con el televisor y el espaciador en el caso de: : Utilice el espaciador suministrado con el televisor para televisores que tengan ●...
  • Página 32 SANUS will not be liable for any damages whatsoever arising out of the use or inability to use its products, even if SANUS has been advised of the possibility of such damages. To the maximum extent permitted by applicable law, SANUS disclaims any responsibility for incidental or consequential damages (such as the cost of repairing or replacing other property which damaged when the device does not work properly).