Brizo 75653 Manual Del Usuario página 7

60 Series Installation
Showerhead and Tub Spout Installation
2
2
FOR SHOWERHEAD INSTALLATION:
Connect top outlet (1) to shower arm (2) with
proper fittings. To prevent damage to finish on
shower arm, insert wall end of shower arm into
shower flange (3) before screwing arm into riser
connection. Thread showerhead (4) onto shower
arm. Apply plumber tape to pipe threads on both
ends. Do not overtighten showerhead.
FOR TUB SPOUT INSTALLATION:
Install 1/2" (13 mm) threaded pipe nipple (1) to
extend past finished wall (2) per dimension (3).
Connection of deck mount spouts to in–wall
valves is not recommended. Neither is the use
of hand showers connected to tub spouts in a
tub/shower push button diverter combination, or
hand showers connected in lieu of a tub spout
to a tub / shower valve.
Piping between valve body and tub spout must
be a minimum of 1/2" (13 mm) copper pipe or
1/2" (13 mm) iron pipe in a straight drop no
less than 8" (203 mm) but no more than 18"
(457 mm) long with only one iron pipe or copper
RP54874s
s Specify Finish
2
(3) = 9/16" ± 1/16" (14.3 mm ± 1.5 mm)
RP49094s
2
s Specify Finish
(3) = 3/8" ± 1/16" (9.5 mm ± 1.5 mm)
1
3
4
90 degree elbow to the tub spout nipple. Apply
plumber tape to threads on pipe nipple and
screw on tub spout.
1
3
(3) = 3/8" ± 1/16" (9.5 mm ± 1.5 mm)
1
3
4
3
2
FOR RSVP SHOWERHEAD AND
®
SHOWER ARM INSTALLATION:
1/2" threaded pipe nipple to extend beyond the
finished wall 3/8" to 1/2". Apply plumber tape to
thread on pipe nipple and screw brass adapter
(1) securely onto nipple. Apply plumber tape to
outlet end of shower arm and screw shower-
head (2) onto the shower arm (3), using
provided wrench (4) to tighten securely. Check
position of set screw on top of shower arm (3)
making sure it is not sticking through to the
inside opening where it could interfere with the
assembly. Slide shower arm and head assembly
over the adapter and tighten set screw against
the adapter.
RP49126s
s Specify Finish
2
(3) = 5 3/8" ± 1/16" (136.5 mm ± 1.5 mm)
RP49345s
s Specify Finish
2
RP64084s Tub Spout & Flange/
Pull Down Diverter
RP49761s Spout Flange
s Specify Finish
(3) = 3/8" ± 1/16" (9.5 mm ± 1.5 mm)
1
4
Install a
1
3
1
3
1
3
2