Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Valve Trim Installation
3
(See page 6 for Siderna
A.
2
1
Slide O-ring (1) over cartridge and the bonnet
nut (2). The O-ring, which acts as a spacer to
steady the sleeve, should rest behind the
bonnet nut.
C.
1
3
Secure the escutcheon (1) to the bracket (2) with
the 2 screws provided (3). Do not overtighten
escutcheon screws.
60 Series Installation
valve trim installation.)
®
B.
2
If your model requires a spacer (1), install it into
sleeve (2). Slide the sleeve over the cartridge, body
and O-ring. Ensure sleeve is properly positioned
over the front of cartridge. Note: RSVP
(series T60X90) do not require spacer (1).
D.
2
2
5
Slide trim ring (1) over the cartridge and sleeve
and into the escutcheon. Install volume control
handle base (2) with lever to the right as shown
(3). Install set screw (4) or (5) followed by the
handle lever (6) or (7).
For RSVP
downward to 6 o'clock position. Install set screw
(8) into handle (9). Push handle onto valve
cartridge and tighten set screw to secure handle.
5
1
3
1
9
4
6
7
models, lever should point
®
models
®
8
Publicidad
Tabla de contenido
