Abicor Binzel ABIPLAS CUT 200 W Instructivo De Servicio página 48

11 Disassembly
11 Disassembly
12 Disposal
12.1 Materials
EN - 24
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the entire welding system.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany
see TRBS 1203).
• Please consult the operating instructions for the welding components,
such as the welding power source and the robot control unit.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-20.
When disposing of the system, local regulations, laws, provisions, standards
and guidelines must be observed. Observe the regulations on the disposal of
electronic scrap and dispose of it at your local waste disposal site (e.g.
recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take
note of the following information:
 11 Disassembly on page EN-24
This product is mainly made of metallic materials, which can be melted down
in steel and iron works and are thus almost infinitely recyclable. The plastic
materials used are labelled in preparation for their sorting and separation for
later recycling.
®
ABIPLAS CUT 200 W/MT