Connecting The Plasma-Cutting Torch; Connecting The Coolant; Risk Of Burns - Abicor Binzel ABIPLAS CUT 200 W Instructivo De Servicio

6 Putting into operation

6.2 Connecting the plasma-cutting torch

6.3 Connecting the coolant

EN - 16
NOTICE
• Make sure that the connections are properly assigned and tightened.
• Since the plasma nozzle cannot be protected against direct contact for
technical reasons, the plasma cutting power source must fulfil the
requirements of EN 60974-7, point 7.4.2.
• The plasma-cutting torch in connection with the plasma power source
must conform to EN 60974-10.
• The plasma power source must also conform to EN 60974-1.
• The plasma power source and cutting torch must have the same type of
ignition (contact or HF) and the same output power (rated current and
corresponding duty cycle).
 Tab. 3 Product-specific torch data (EN 60 974-7) on page EN-8
WARNING

Risk of burns

If the coolant level is too low, the plasma-cutting torches will overheat.
• Wear protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Ensure that the coolant supply and return hoses have been correctly
installed. Coolant supply = blue, coolant return = red.
• Do not use deionised or demineralised water as coolant or for leak and
flow tests. This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using
ABICOR BINZEL BTC coolant.
®
ABIPLAS CUT 200 W/MT