Operation - FRICON CLS Uso Y Mantenimiento

SMR
• Check if the power source's voltage and respective frequency correspond to the
recommendations in the appliance's characteristics label found on the back
(Fig.4).
• The maximum impedance of the equipment's power supply network should be
0.33 ohms.
• Any work on the electrical system, repair or replacement, must be carried out
by authorized FRICON technicians. To request assistance, contact FRICON
customer service.
• Do not use inappropriate adapters, power strips, or extension cords. They may
cause overheating and burn. The manufacturer will decline any liability for
damages caused to people or objects resulting from non-compliance with this
standard.

7. Operation

This equipment is projected to operate at a certain room temperature and relative
humidity found in the climate classification indicated on the characteristics label, as
seen on chapter 2.
Make sure that the wall and floor racks are always inside the equipment.
NOTES:
• Doors are standard with the equipment. Doors are necessary for the equipment
to operate appropriately. They should only be opened to place and remove
products.
• In equipment with the automatic defrost feature, defrost times are predetermined
in the control panel. It automatically defrosts every day during the night.
Instructions for manual regulation are found under point "8.1 Manual Defrost".
• During the defrosting period, products do not suffer any damages as the
temperatures prescribed in the regulation are not exceeded.
• In non-ventilated equipment, when in Chiller mode, there must be no products
below the step height due to freezing risk.
CAUTION
•
Defrosting water may come out of the equipment. If that is the case, said water
must be removed to avoid slipping hazard.
CAUTION
•
Do not climb on or get inside the equipment. The material could break and there is
a risk of physical damages and damages to the equipment.
WARNING
42
English