Install The Side Panels; Install The Header - Kohler K-1000-H2 Guia De Instalacion

Locating Pin
Center
Support

14. Install the Side Panels

NOTE: The locating pins have been factory installed to help position the side panels and center supports.
Do not remove, reposition, or modify the locating pins. Altering the locating pins will modify the fit and
reduce the sealing ability of the door panels and may void warranty coverage of this product.
Slide one of the side panels into the wall jamb so the larger horizontal frame is on top. The side
panels are not interchangeable. Insert the side panel fully into the wall jamb, then raise and pivot
the side panel so the center pocket fits against the locating pin.
Attach a center support to the center frame of the side panel assembly. Connect the edge of the
center support to the side panel, and pivot the center support until it rests inside the side panel.
Secure with eight #8 x 3/8" panhead screws. Do not overtighten.
Repeat for the other side panel.

15. Install the Header

With assistance, lift the header between the center supports so the bottom dimpled holes in the
header brackets fit over the adjustment screws.
Check the alignment of the side holes in both header brackets to the adjustment screw heads. If the
holes do not line up, loosen the setscrews in the header bracket(s), and realign the header bracket(s)
until the holes align with the adjustment screw heads. Retighten the header bracket setscrews.
Add a 1/4" flat washer to each of the two buttonhead screws. Thread a buttonhead screw and
washer through each header bracket top hole, and into the center support.
Securely tighten each buttonhead screw with the supplied hex tool and ratchet wrench.
1032108-2-A
TOP VIEW
Locating
Pin
Wall Jamb
Footbath
Side Panel
#8 x 3/8"
Panhead Screws
1/4" Washer
1/4-20 x 5/8"
Buttonhead
Screw
Header
Bracket
14
Header
Setscrew
Adjustment
Screw
Center Support
Kohler Co.