NEC NP2000 Manual Del Usuario página 81

[Entry Edit Command]
You can edit signals on the [Entry List].
Load ...................... Enables you to select a signal from the list.
Store ..................... Enables you to store the currently projected signal.
Cut ........................ Enables you to remove a selected signal from the list and place it on the "clipboard" in the projector.
Copy ...................... Enables you to copy a selected signal from the list and place it on the "clipboard" in the projector.
Paste ..................... Enables you to paste the signal placed on the "clipboard" to any other line of the list.
Edit ........................ Enables you to change source names.
Source Name:
Enter a signal name. Up to 18 alphanumeric characters can be used.
Input Terminal:
Change the input terminal.
Lock:
Set so that the selected signal cannot be deleted when "All Delete" is executed. After executing [Lock], the
changes cannot be saved.
Skip:
Set so that the selected signal will be skipped during auto search.
When complete, select OK and press ENTER. To exit without storing the setting, select Cancel. Select [Source
Name] and press ENTER to display the Source Name Edit window. You can change source name on this
window. Press
128
All Delete ............... This feature enables you to delete all the registered signals in the Entry List.
The following buttons are not available for the currently projecting signals:
1) The Cut and Paste buttons on the [Entry Edit Command] screen
2) The Input Terminal button on the [Entry Edit] screen
NOTE: When all the signals in the [Entry List] are deleted, the currently projected signal will be also deleted except locked signals.
to display the software keyboard, which you can enter alphanumeric characters. See page
for the key function of the software keyboard.
71
6. Using On-Screen Menu